Zanussi ZDC 47100 W - Manual (Page 20)

20
It is dangerous to alter the
specifications or attempt to
modify this product in any
way.
Care must be taken to ensure
that the appliance does not
stand on the electrical supply
cable.
Any electrical work required
to install this appliance
should be carried out by a
qualified electrician or com-
petent person.
Important:
The appliance must not built-in..
Unpacking
Slide out the polythene bag with the
polystyrene stuffing before using the
appliance Pull off adhesive strips from
inside machine on top of drum.
Should the appliance be moved, it
must be transported vertically.
The appliance must not be installed
behind a lockable door, a sliding
door a door with a hinge on the
opposite side to that of the
appliance.
Positioning
It is recommended that, for your
convenience, the machine is positioned
close to your washing machine.
The tumble dryer must be installed in a
clean place, where dirt does not build
up.
Air must be able to circulate freely all
round the appliance. Do not obstruct
the front ventilation grille or the air
intake grilles at the back of the
machine.
To keep vibration and noise to a
minimum when the dryer is in use, it
should be placed on a firm, level
surface.
Once in its permanent operating position,
check that the dryer is absolutely level with
the aid of a spirit level. If it is not, raise or
lower the feet until it is.
The feet must never be removed. Do not
restrict the floor clearance through deeppile
carpets, strips of wood or similar. This
might cause heat build-up which would
interfere with the operation of the
appliance.
Important:
The hot air emitted by the tumble
dryer can reach temperatures of up to
60°C. The appliance must therefore
not be installed on floors which are
not resistant to high temperatures.
When operating the tumble dryer, the room
temperature must not be lower than +5°C
and higher than +35°C, as it may affect the
performance of the appliance.
Stacking kit
A special stacking kit is available
through your dealer, to enable the
mounting of the dyer on top of a front
loading washing machine with cover’s
Installation