Zanussi ZDC 47100 W - Manual (Page 11)

11
Cotton Cycle: to be
used for cotton,
where as in the pro-
grammes
When the pro-
gramme has fin-
ished the pilot lights
End is on.
Synthetics to be used for synthetic or
delicate items.
When the programme has finished the
pilot lights End is on.
9. Select the Start/Pause
Press this button to
start the dryer after
having selected the
programme and the
options.
The relevant light
will stop flashing. If
the programme
selector dial is turned to another posi-
tion, when the machine is running, the
buzzer will sound and the programme
phase indicator lights will flash.
The drum turns alternately in both
directions during drying. All drying pro-
grammes end with a 10 minute cooling
phase (light Cooling is on). You may
remove the laundry after this phase.
The lights Empty Tank and Filter illumi-
nate and the buzzer sounds.
If the door of the appliance or the small
door at the bottom is opened while the
programme is running, this button must
be pressed again after closing the door
in order to restart the programme from
the point at which it was interrupted.
This button must be depressed also
after a power failure and after having
reinserted the water reservoir, if it has
been emptied in the middle of a pro-
gramme after lighting up of light Empty
Tank.
In both cases the light of the
Start/Pause button flashes to remind
you that the start button needs to be
pressed again.
10. Indicator lights
These lights indicate the following func-
tions:
“Drying” light
This light indicates
that the appliance is
in the drying phase.
“Cooling” light
This light indicates
that the appliance is
in the cooling phase. At the end of dry-
ing, there is a 10 minute cooling phase
to cool the laundry.
“End of programme” light
This light is on at the end of the cool-
ing phase, during the anti-creasing
phase and at the end of the pro-
gramme.
“Filter cleaning” light
This light illuminates at the end of the
programme to remind you that the fil-
ters must be cleaned.
“Empty tank” light
This light comes on at the end of the
programme to remind you that the
water reservoir must be emptied out. If
this light illuminates during a pro-
gramme this means that the water
reservoir is full. The buzzer sounds,
the programme stops, the light of the
Start/Pause button flashes.
“Condenser cleaning” light
It comes on every 80 cycles to remind
you that the condenser must be