Factory defaults, 3 factory defaults – ZyXEL Communications ZYAIR B-4000 User Manual
Page 4
ZyAIR B-4000
3
Figure 2 ZyAIR Front Panel
Table 2 Front Panel LEDs
LED STATUS
DESCRIPTION
PWR
On (Green)
The ZyAIR is receiving power.
Off
The ZyAIR is not receiving power.
WAN
On (Green)
The WAN port has a connection to your cable or DSL modem.
Blinking (Green)
The WAN port is sending or receiving packets.
Off
The WAN link is not ready, or has failed.
LAN (1-4)
On (Green)
The port is connected to a 10/100Mbps Ethernet device.
Blinking (Green)
The port is receiving or sending data.
Off
The port is not connected to a 10/100Mbps Ethernet device.
WIRELESS
On (Green)
The ZyAIR has established a wireless LAN connection.
Blinking (Green)
The ZyAIR is sending/receiving data through the wireless LAN.
SYS
On (Green)
The ZyAIR is ready and running.
Blinking (Green)
The ZyAIR is upgrading its firmware.
Off
The ZyAIR is not ready or has failed.
1.3 Factory Defaults
Table 3 Factory Defaults
Username
“admin” (case sensitive)
WAN IP Address
DHCP Client (dynamic WAN IP)
Password
“1234”
LAN IP Address
192.168.1.1
LAN
DHCP
Server