Zebra Technologies R2844-Z - Manual (Page 49)

^RS – RFID Setup (continued)
If the read/encode retries exceed the number set by the "n" parameter, an
error will be sent to the host as an unsolicited message. To control the
unsolicited message, use the ZebraNet Alert commands (^SX and ^SQ) and
set the "condition type" parameter to "P."
Note • Use caution when using this function in combination with ^RI (reading the
unique ID number) or ^RT (reading tag data). Problems can occur if the data read
from the tag is going to be printed on the label. Any data read from the transponder
must be positioned to be printed above the read/write position. Failure to do this will
prevent read data from being printed on the label or tag.
980476-001A 41