Yamaha MS40DR EN - Manual (Page 7)

MS40DR Owner’s Manual 7
1.
First insert the speaker mount of the satellite
speaker into the hole q of the pipe clamp, then
tighten the screw firmly by using the included hex
key.
2.
As shown in Figure A, slowly insert one leg of your
drum rack through the hole w of the pipe clamp.
When you finish adjusting the position, tighten the
screw firmly by using the included hex key as
shown in Figure B.
• Be sure to tighten the screws securely.
3.
See Figure C. Place the Subwoofer speaker on a flat floor.
4.
Connect the satellite speakers, subwoofer speaker, and the drum trigger module via the included cable as shown
in Figure C.
5.
Plug the AC power cord into an AC wall socket or another electrical outlet.
Installing the Monitor Speaker
CAUTION
• Be sure to attach the satellite speaker to
the leg of the drum rack slowly.
Hex key
(included)
Pipe clamp
q
Speaker mount
Satellite
speaker
Hex key (included)
Drum rack leg
[Figure A]
[Figure B]
w
CAUTION
• Even when the
power switch is in the OFF ( ) position, a small amount of electricity is still flowing
to the unit. When you are not using the MS40DR for a long time, make sure to unplug the AC power
adaptor from the wall AC outlet.
Satellite
speaker
Drum trigger module
Subwoofer speaker
Satellite
speaker
Red
White
Red
Red
White
Red
White
White
[Figure C]
OUTPUT L/MONO
OUTPUT R
* For the stereo audio cables, red indicates the right channel, and white indicates the left.