ZyXEL Communications NSA-2400 - Manual (Page 4)

NSA-2400 Quick Start Guide
4
2 Connect one end of the power cord to the power socket on the rear of the
NSA and the other end to the external power supply. Connect the external
power supply to a power outlet.
3 Turn on the power by pressing in the power button on the front of the NSA.
Look at the front panel lights. The PWR light turns steady green. The SYS
light turns steady green after the NSA has booted successfully (it takes
about 50 seconds). The LAN light turns on if the NSA Ethernet port is
properly connected to your network. It blinks while transmitting or receiving
traffic.
Note: To turn off the NSA, press the power button in once only. The SYS
light blinks red indicating the NSA is shutting down.
3 Access the NSA
You can access the NSA in one of two ways: using the NDU (NSA Discovery
Utility) or directly entering the NSA IP address into your web browser.
3.1 Use the NDU to Discover the NSA IP Address
Use the NDU (NSA Discovery Utility) on a Windows computer if your network has a DHCP server that will
assign the NSA an IP address and/or if you have many NSAs in your network.
Note: The Genie Backup program uses the same network port as the NDU to discover the NSA. To
avoid a port conflict, do not run the Genie Backup at the same time as the NDU.
1 Insert the included CD into your CD-ROM drive.
The next screen should automatically display
(autorun). Click the Setup icon.