ZyXEL Communications NSA-2400 - Manual (Page 3)

NSA-2400 Quick Start Guide
3
2 Pull out the latch and grip the sides of the
tray to remove disk tray 1. Be careful not
to break the latch. Disk bay 1 is labelled on
your NSA (the top-left bay).
3 Place the disk tray on a flat surface with
the panel facing up. Place a hard disk with
the screw holes facing up on the same
surface and slide it into the disk tray.
Secure it with the screws as shown.
4 Push the top of the tray back into NSA disk
bay 1 until it snaps into place and push the
latch up as shown.
5 Repeat steps 1 to 3 for other hard drives
that you may have.
2 Make the NSA
Connections
1 Connect the Ethernet port on the rear of the NSA to a hub, switch, or
router on your network using an Ethernet cable. Use an 8-wire Ethernet
cable for Gigabit connections.