ZyXEL Communications P-2002 - Manual (Page 59)

P-2002 Series User’s Guide
Chapter 6 VoIP Screens 59
6.3 Custom Tones (IVR)
IVR (Interactive Voice Response) is a feature that allows you to use your telephone to interact
with the Prestige device. The Prestige allows you to record custom tones for the Caller
Ringing Tone and On Hold Tone functions.
• You can record up to ten different custom tones for a total time of 120 seconds.
• An individual tone can last up to 20 seconds.
• For example you could record up to ten 12-second tones or up to six 20-second tones.
• The same recordings apply to both the caller ringing and on hold tones. This means that
the drop-down list boxes in the Advanced VoIP Settings screen include the same tones
for both caller ringing and on hold.
6.3.0.1 Recording Custom Tones
Use the following steps if you would like to create new tones or change your tones:
1 Pick up the phone and press “****” on your phone’s keypad and wait for the message
that says you are in the configuration menu.
SIP Server Port Enter the SIP server’s listening port for SIP in this field. Leave this field set to the
default if your VoIP service provider did not give you a server port number for SIP.
REGISTER
Server Address
Enter the SIP register server’s address in this field.
If you were not given a register server address, then enter the address from the
SIP Server Address field again here.
REGISTER
Server Port
Enter the SIP register server’s listening port for SIP in this field.
If you were not given a register server port, then enter the port from the SIP
Server Port field again here.
SIP Service
Domain
Enter the SIP service domain name in this field (the domain name that comes after
the @ symbol in a full SIP URI). You can use up to 127 ASCII Extended set
characters.
Authentication
User ID
This is the user name for registering this SIP account with the SIP register server.
Type the user name exactly as it was given to you. You can use up to 95 ASCII
characters.
Authentication
Password
Type the password associated with the user name above. You can use up to 95
ASCII Extended set characters.
Sending Caller
ID
Select this check box to show identification information when you make VoIP phone
calls. Clear the check box to not show identification information when you make VoIP
phone calls.
Incoming Call
apply to
Phone 1 and Phone 2 correspond to the Prestige’s physical PHONE 1 and 2 ports,
respectively. Select whether you want to receive calls for this SIP account on Phone
1, Phone 2 or both. If you select both, you will not know which SIP account a call is
coming in on.
Advanced
Settings
Click Settings to open a screen where you can configure the Prestige’s advanced
VoIP settings like SIP server settings, the RTP port range and the coding type.
Apply Click Apply to save your changes back to the Prestige.
Reset Click Reset to begin configuring this screen afresh.
Table 12 VoIP (continued)
LABEL DESCRIPTION