Xerox DC230LP - Manual (Page 3)

7
+(
'
2&80(17
&
203$1<
DC230LP Windows NT ® 4.0 TCP/IP Quick Install
Page 3 of 4
d) Press [ ] repeatedly to delete the
current entry.
e) Use the [ ] or [ ] key to select the
first character in the Printer Name.
f) Press [ ] to move to the next charac-
ter. Repeat this procedure to enter the
entire Printer Name.
g) Press [Enter]. **SAVED** displays
momentarily, followed by
.
10.
Enable the Line Printer Daemon (LPD):
a) Press [Escape] to move back a level
in the menu system.
displays.
b) Press [ ] until
displays.
c) Press [ ]. displays.
d) Press [ ]. displays.
e) Press [ ] until
displays.
Printer Name
(your entry) >
TCP/IP - >
Line Printer
Daemon >
Enablement
(current entry) >
Enablement =
(current entry) *
Enablement =
Enabled
f) Press [Enter]. **SAVED** displays
momentarily, followed by
.
Note: The next menu at this level, Port Setting ,
has a fixed setting for the LPD (515) and can not
be changed.
11.
Save all settings:
a) Press [Online].
displays.
b) Press [Enter].
displays. The DC230LP will reboot,
save the settings entered, and print a
Configuration Report in approximately
3 minutes.
12.
Check the settings on the Configuration
Report against those entered to be sure
they are correct.
Enablement
Enabled >
Reset Required
Press ENTER key
Warming Up
Please Wait . . . >
13.
At the client, install print drivers and map
the printer in the usual manner. Refer to
the CentreWare
® manual, Getting Started
with Print and Fax Services , for additional
information.
14.
TCP/IP protocol and TCP/IP print services
must be installed on the NT Server and the
printer name must be set to [lp] (lower
case) when configuring the LPR port.
Refer to the screen sample below.
Additional information on the Windows NT
TCP/IP setup can be found in the
DC230LP
System Administration Guide, Network Installa-
tion and Troubleshooting
.