Zebra Technologies A100 - Manual (Page 23)

Zebra )100 User’s Guide
&
Specifications
Print density 203 dots/inch 8 dots/mm
Print width 1 ² to 4.125² 25.6 to 105.0 mm
Print speed 2 ²/sec 51 mm/sec
Label width (including backing
material, if any) 1
² to 4.25²
25 to 108 mm
Label length 0.5 ² to 8² 12.7 to 203 mm
Interlabel gap 0.08 ² to 0.16² 2 to 4 mm
Label thickness (including backing
material, if any) 0.003
² to 0.010²
0.076 to 0.254 mm
Label roll size Maximum outer
diameter 5.0 ² 127 mm
Minimum inner
core diameter 1.0 ² 25.4 mm
Registration toler-
ance Horizontal ± 0.059
²
± 1.5 mm
Vertical ± 0.0393 ² ± 1.0 mm
First dot location (from outer media
edge) 0.125 ² to 0.140² 3.17 to 3.56 mm
Fonts available All Windows fonts resident in the host computer or Win-
dows application.
Bar codes available All bar codes available in the Windows application.
Media requirements Zebra recommends use of Zebra brand media. All media
must be direct thermal media. Media may be continuous,
die-cut, or notched. Notched media must have a notch
which is 1/4
² wide ´ 3/32² long located on the left side
of the label as it feeds through the printer.
Physical size (L ´ W ´ H) 9.7 ² ´ 7.0² ´ 6.0² 249 mm ´ 179 mm ´
154 mm
Weight (without media) 3.35 lb 1.52 kg
Temperature
range Operating 50° to 104° F 10° to 40° C
Storage -4° to 140° F -20° to 60° C
Relative humidity, operation and
storage 10 to 90% R.H.
Electrical External 120 or 230 VAC power supply, depending on
which model you order. Additional custom line cords
may also be available.
Communications 36-pin Centronics™-compatible parallel port
55501lr3 Page 18 Wednesday, March 26, 1997 1:08 PM