Yeoman EXMOOR YM-W9001FL - Manual (Page 7)

77
UsER INsTRUCTIONs
• Leave the door slightly open as the fire establishes and
the glass warms to avoid the build-up of condensation
• Add larger pieces of wood
Too many logs may smother the fire.
Do not load fuel above the log guard and the secondary
combustion holes at the back of the firebox.
See Diagram 7
Secondary Combustion holes
Log Guard
PR8252
• Close the door
Do not leave the door open as this could over-fire and
damage the appliance .
5. RUNNING THE APPLIANCE
5.1 Burning Wood (with or without Multi-fuel kit fitted):
• Leave the Secondary Air fully open
• Close the Primary air control and use the Airwash to
control the burn rate when appliance is at operating
temperature, see Diagram 8
Secondary Air:
Fully Open
Primary Air:
Closed
Secondary Air:
Fully Open
Primary Air:
Closed
Air Wash: Fully Open
Air Wash: Fully Open
• Wood burns best on a bed of ash
• Rake the embers evenly over the fire bed and open the
Airwash control fully for a few minutes before re-fuelling
5.2 Burn new logs at high output for a few minutes before
adjusting the Airwash control. Refuel little and often for
clean, efficient burning.
5.3 Experience establishes settings to suit personal preferences.
5.4 Do not burn large amounts of fuel with the Airwash control
closed for long periods of time. This reduces the glass
cleaning effect and causes tars and creosotes to build-up in
the appliance and flue system.
5.5 When in use, burning the appliance at high output for a
short period also reduces tars and creosote.
5.6 Burning solid fuel (with Multi-fuel kit fitted):
• Set air controls, See Diagram 9
• To burn solid fuel efficiently it is best to control the
combustion using the Primary air control only