WatchGuard VPN v10.0 - Manual (Page 27)

Administrator Guide 25
Installing the Mobile VPN with IPSec Client
Importing the end-user profile
When the computer restarts, the WatchGuard Mobile VPN Connection Monitor dialog box opens.
When the software starts for the first time after you install it, you get this message:
There is no profile for the VPN dial-up!
Do you want to use the Configuration Assistant for generating a profile now?
Click No. See the next section for instructions on how to import a client profile.
To turn off the Connection Monitor auto-start functionality, select
Window > AutoStart > No Autostart.
To import a Mobile VPN configuration .wgx file:
1 Select Configuration > Profile Import.
The Profile Import Wizard starts.
2 On the Select User Profile screen, browse to the location of the .wgx configuration file supplied
by your network administrator. Click Next.
3 On the Decrypt User Profile screen, type the shared key or passphrase supplied by your
network administrator. The shared key is case-sensitive. Click Next.
4 On the Overwrite or add Profile screen, you can select to overwrite a profile of the same name.
This is useful if your network administrator gives you a new .wgx file and you must reimport it.
Click Next.
5 If you connect to a Firebox X Edge, click Finish.
If you connect to a Firebox running Fireware appliance software, click Next.
6 On the Authentication screen, you can select whether to type the user name and password that
you use to authenticate the VPN tunnel. If you keep these fields clear, you are prompted to enter
your user name and password each time you connect to the VPN.
If you type your user name and password here, the Firebox stores it and you do not have to enter
this information each time you connect. However, this is a security risk. Optionally, you can type
just your user name and keep the Password field clear. This can minimize the amount of data
required for the VPN connection.
Click Next.