Installer/configuration menu – White Rodgers BLUE 2 1F89-0211 User Manual

Page 5

4) Select Compressor Lockout CL OFF or ON - Selecting

CL On will cause the thermostat to wait 5 minutes between
cooling cycles. This is intended to help protect the
compressor from short cycling. Some newer compressors
already have a time delay built in and do not require this
feature. Your compressor manufacturer can tell you if the
lockout feature is already present in their system. When the
thermostat compressor time delay occurs, it will fl ash the
setpoint for up to fi ve minutes.

5) Select Backlight Display - The display backlight improves

display contrast in low lighting conditions. When the “C”
terminal is connected, selecting backlight CdL On will keep
the light on continuously. Select backlight OFF will turn the
light on momentarily when any key is pressed. When the
“C” terminal is not connected, regardless of the backlight
selection, the light will be on momentarily when any key is
pressed.

6) Select Temperature Display Adjustment 4 LO to 4 HI -

Allows you to adjust the room temperature display up to 4°
higher or lower. Your thermostat was accurately calibrated
at the factory but you have the option to change the display
temperature to match your previous thermostat. The
current or adjusted room temperature will be displayed on
the display.

7) Select F° or C° Readout - Changes the display readout to

Celsius or Fahrenheit as required.

8) Select Fast Second Stage ON or OFF - (Heat Pump Only)

In the HEAT mode, with the Fast Heat feature enabled (FH
Heat On), if the temperature is manually raised by 3°F (2°C)
or more above the actual temperature using the

, the

second stage will energize immediately. With FH OFF, the
thermostat will determine the optimum time (approximately
0 to 30 minutes) to use Auxiliary/Second stage heat in
addition to the Heat Pump.

9) Select Filter Replacement Reminder and Set Run Time

Select the “Change Filter” reminder On or OFF. If selected
On, press

and

to select the time period from 25 to

1975 hours in 25 hour increments. In a typical application,
200 hours (default) of run time is approximately 30 days.
After the selected time of blower operation, the thermostat
will display “Change Filter” as a reminder to change or
clean your air fi lter. When “Change Filter” is displayed,
press the

and

button to clear the display and

restart the time to the next fi lter change. A selection of OFF
will cancel this feature.

Confi guration Menu

Menu

Reference

Number

Press

Key

Displayed

(Factory

Default)

Press

to select

from listed op-

tions

Comments

and

(OFF)

Select Cool Savings Feature On or OFF

and

(3)

1, 2, 3, 4, 5, 6

If CS selected On, selects Cool Savings value

and

CR HE-PU

(FA)

Select Adjustable Anticipation, cycle rate, Heat
Pump, Heat and Cool

and

CR Aux

(FA)

Select Adjustable Anticipation, cycle rate,
Heat Pump Aux Stage

and

(OFF)

Select Compressor lockout OFF or On

and

(On)

OFF

Select Display Light On or OFF

and

Temp

(0 HI)

4 LO to

4 HI

Select temperature display adjustment higher
or lower

and

Select

F /

C Display (temperature units in

Fahrenheit or Celsius)

and

(On)

OFF

Select fast second stage On or OFF

and

Change Filter

(OFF)

Select fi lter replacement indicator OFF or On

and

Change Filter

(200 h)

25 to 1975

If Change Filter selected On, selects time inter-
val for Change Filter Indicator.
(in 25 hour increments)

and

Returns to normal operation

INSTALLER/CONFIGURATION MENU