Wasp Bar Code WLP 4170 CCD - Manual (Page 13)

*Default
00 Default* 04 Continuous
10
Setup & Configuration
—Scanning Modes
Begin
Set Scanning Mode
Exit
The 'Scanning Mode' option controls the trigger and LED settings for the WLP
4170 CCD Scanner.
NOTE: For help in configuring these settings, consult the programming
steps on page 5.
Continuous Mode
* Trigger with 10 Sec. Delay
When this option is selected, the LEDs are
visible at all times. Under this option, you cannot
read the same bar code back-to-back.
This is the default option for the
Wasp WLP 4170 CCD Scanner.
When this option is selected, the
scanner will stop scanning when
there is a successful read or no
code is scanned after 10 seconds.