Wasp Bar Code WLP 4170 CCD - Manual (Page 11)

8
Setup & Configuration
—Intercharacter Delay
Intercharacter Delay Settings
00 Slowest
01 Slow
02 Default
50 Medium
75 Fast
99 Fastest
The 'Intercharacter Delay' configuration sets the speed at which the WLP 4170
CCD Scanner sends data. The intercharacter delay should be changed only if
the transfer rate cannot be maintained between WLP 4170 CCD Scanner and
the keyboard buffer of the computer.
Note: The default for the intercharacter delay is set to '2ms' and is the most
common configuration; however, your PC may be different.When you scan a bar
code, if some characters are missing, decrease the intercharacter delay speed
to speed up the transfer rate. If some stray or scrambled characters appear on
your screen, increase the intercharacter delay to slow down the transfer rate.
NOTE: For help in configuring these settings, consult the programming
steps on page 5.
Begin
Set Intercharacter
Delay
Exit