Wasp Bar Code WLP 4170 CCD - Manual (Page 10)

7
Setup & Configuration
—Beep and Delay
Beep Volume Settings
00 None
01 Lowest
02 Low
03 Medium (Default)
04 Medium-High
05 High
06 High-Medium
07 Highest
The 'Beep Volume' configuration changes the volume of the audible indicator of
the WLP 4170 CCD Scanner.
NOTE: For help in configuring these settings, consult the programming
steps on page 5.
1. Scan “Begin ”
2. Scan “Set Beep Volume”
4. Scan the “Set” barcode on
the back cover flap
5. Scan the “Exit” barcode
3. Pick a setting from the table
at right, then turn to the
back cover flap and scan
the corresponding two
digits. For example: if you
desire no beep, scan 0 and
0 on the back cover flap
Begin
Set Beep Volume
Exit