Winegard AS-2003 - Manual (Page 16)

16
4. Mount the wall plate controller flush with the wall or inside a cabinet. Push the wire
harness through the hole, connect to the wall plate and secure screws.
You can also use the surface mount box (provided), Figure 12.
When using mount box, you may
have to knock out the portion
of the box indicated
by the dotted line in
Figure 12.
Mounting interior wall plate controller
Inside your vehicle, choose a convenient location for the wall plate controller. Con-
sider wiring layout and distance from your television set. The wall plate uses the
nine-wire mulit-colored cable.
1. Strip end of each wire. Place in harness in the locations indicated in Figure 11. Be
sure there are no individual “strays” from the wires that are not in the slot. These
“strays” can interfere with operation.
2. After putting each wire in the appropriate slot, tighten the screw.
3. When all wires are in place in the harness end, plug this into the back of your wall
plate control panel, as shown in Figure 11. DO NOT plug in upside down or incor-
rectly; your unit will not operate, or you may cause irreparable damage. Note label
on board to help with positioning of plug.
FIGURE 11
Surface Mount
Box for Wall
Plate Controller
Box can be
mounted two
ways, as shown.
FIGURE 12
1. WHITE
2. PURPLE
3. BLUE
4. GREEN
5. YELLOW
9. BLACK
8. BROWN
6. ORANGE
7. RED