Winegard AS-2003 - Manual (Page 15)

15
15. BEFORE YOU INSTALL THE BASE COVER,
you must SET THE SWITCHES in the outside unit.
Decide which programming you will be using.
This will determine how you set your switches.
To set the switches for the satellite used by your
programming provider, remove the small plate
on the side of the electronics box, Figure 9. You
will need a Phillips screwdriver.
The switches will appear upside down, numbers will be
counter-clockwise. Set numbers right to left.
14. Install the vent tube on the back of the mount
base (This is the side opposite the word
FRONT). The hole for the vent tube is shown in
Figure 8. CAUTION: DO NOT seal the hole in
vent tube. Put sealant around the outside of
the vent tube, approximately 1/2 inch from end.
Push the vent tube into the vent tube hole,
Figure 8. The sealant will seal the hole as you
push in. Leave approximately 2 to 2-1/2 inches
of the vent tube extending from the hole. DO
NOT APPLY SEALANT TO ANY SURFACES
UNTIL YOU TEST YOUR UNIT.
FIGURE 8
Vent tube hole
Vent tube Sealant
1/2”
16. After setting the switches, replace the small plate shown in Figure 9. Be sure to tighten securely;
the insulating material on the inside surface provides weather protection.
FIGURE 9
Remove to
set switches
For DIRECTV ®
set switches
to 101°.
For DISH
Network
®
set to 119°.
For ExpressVu ®
set switches
to 092°.
TEST UNIT TO BE SURE IT OPER-
ATES PROPERLY BEFORE YOU
APPLY ANY SEALANT!
Use a sealant compatible with your
roof material.
17. Install the base cover, Figure 10.
a. Place cover on unit.
b. Line up holes in cover to holes in
motor housing and electrical box.
Use COARSE THREAD
SCREWS to attach to MOTOR
HOUSING.
Use FINE THREAD SCREWS for
ELECTRICAL BOX.
Shroud
2200732
Fine Thread
Screw
2160090
Coarse Thread Screw
2160091
>
>
Mount Assembly AS-2003
(partial view)
FIGURE 10
RM-8000_9