Whirlpool WHES30 - Manual (Page 19)

19
Program the Water Softener -- Model WHES30
UP button
DOWN Button PROGRAM button RECHARGE button
Display
PRESS TO SCHEDULE
HOLD TO START
+
−
PROGRAM
RECHARGE
SET
SALT
LEVEL
CHECK
SALT
LEVEL
SET SALT LEVEL button
Figure 11
If you have questions about installation, programming, operating and routine maintenance...
call 1--866--986--3223, Monday -- Friday, 8 am to 9 pm, EST.
When the transformer is plugged into the electrical outlet, a model code and a test number (example:
s3.0), begin to flash in the faceplate display. Then, 12:00 PM and the words “CURRENT TIME” begin
to flash.
NOTE: If -- -- -- -- shows in the display, press the UP
+
or DOWN
−
button until LE31
shows in the display. Then, press the PROGRAM button to set, and change to the
flashing CURRENT TIME display.
Set Time of Day
If the words “CURRENT TIME” do not show in the display, press the PROGRAM button until
they do.
1. Press the
+
Up or
−
Down buttons to set the present time. Up moves the display ahead; down
sets the time back.
Be sure AM or PM is correct.
NOTE: Press buttons and quickly release to slowly advance the display. Hold for fast
advance. This procedure applies for all following settings.