Wacom Cintiq DTZ-2000W - Manual (Page 20)

Installation
Page 18
LCD monitor cabling diagram
Cintiq, rear view
– B –
Video card
DVI or VGA
Rear panel of your computer
Do not attach the USB data
cable until instructed to do so.
Power adapter
– C – DC I N put
To AC outlet
DVI-I connector
To connect to a DVI-D connector, use
the DVI-D to DVI-I adapter cable.
To connect to a VGA connector, use
the VGA to DVI-I adapter cable.
– D –
C AUTION Make sure your video card
has a DVI or VGA connector,
and that you correctly set
the Cintiq Digital/Analog
(DVI/VGA) switch for the
video connector you are
using.
C AUTION Use only the power adapter that came with Cintiq; use of an improper power adapter may
damage the unit.
Do not connect or disconnect the video or power cables while Cintiq or your computer
are turned on – this can damage the LCD monitor or computer video card.
Make sure that the display refresh rate does not exceed 75 Hz (60 Hz for WSXGA).
D IGITAL /A NALOG (DVI/VGA) switch – A –
Cintiq20WSX_Manual.fm Page 18 Monday, January 15, 2007 9:23 AM