Wayne-Dalton TORQUEMASTER 46 - Manual (Page 17)

17
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
Tools Needed:
INST
All
ATION
16
15
horizontal Track
With horizontal tracks installed you can
adjust the top brackets.
Vertically align the top section with the
lower sections. Once aligned, position
the top roller in the top bracket slide out
against the horizontal track. Maintaining
the slide’s position, tighten 1/4”- 20
flange hex nut to secure the top bracket
slide to the top bracket base.
Repeat for other side.
Adjusting Top brackets
7/16” Wrench
Step Ladder
hORIzONTAL
TRACk
TOP BRACkET
SLIDE
CORRECT
INCORRECT
TOP ROLLER
TOP
SECTION
TOP
SECTION
TOP
SECTION
(2) 1/4”- 20 X 5/8”
CARRIAGE BOLTS
fLAGANGLE
fLAGANGLE
(1) 3/8-16 X 3/4”
hEX hEAD BOLT
hORIzONTAL
ANGLE
To install horizontal track, place the curved end over the
top roller. Align the bottom of the horizontal track with
the vertical track. hand tighten the horizontal track to
the flagangle with (2) 1/4”-20 x 5/8” carriage bolts and
(2) 1/4”-20 flange hex nuts.
Level the horizontal track assembly and bolt the horizontal
angle to the slot in the flagangle using (1) 3/8”- 16 x 3/4”
hex head bolt and (1) 3/8”- 16 hex nut. Repeat for other
side.
Tighten the remaining carriage bolts and nuts to complete
the horizontal track installation.
DO NOT RAISE DOOR uNTIL hORIzONTAL TRACkS
ARE SE CuRED AT REAR, AS OuTLINED IN STEP
27, OR DOOR COuLD fALL fROM OVERhEAD
POSI TION CAuSING SEVERE OR fATAL INjuRy.
Remove the nail that was temporarily holding the top section
in place, installed in Step 13.
IMPORTANT: fAILuRE TO REMOVE NAIL BEfORE
ATTEMPTING TO RAISE DOOR COuLD CAuSE PERMANENT
DAMAGE TO TOP SECTION.
NOTE: If an
idrive ® opener will be installed, position
horizontal tracks slightly above level.
9/16” Socket
7/16” Socket
Ratchet Wrench
9/16” Wrench
Level
hammer
Step Ladder
(2) 1/4”-20 fLANGE
hEX NuTS
(1) 3/8”-16
hEX NuT
wARNINg