Windsor GROUTHOG GH3 - Manual (Page 4)

OPERATION
GROUTHOG 86038000 05/17/07 4
SELECT THE RIGHT CHEMICAL FOR THE JOB:
1. For greasy or oily soil – Use a heavy-duty
degreaser.
2. For sealer or old wax - Use a heavy-duty
stripper.
3. For soap residue and lime build-up – Use a mild
acidic cleaner.
4. For routine maintenance – Use an all-purpose
cleaner.
Consult your Windsor
dealer for proper
chemicals. Always follow directions on the
container of the chemical being used.
SELECT THE RIGHT BRUSH FOR THE JOB:
1. For routine maintenance use the Universal
STANDARD Brush.
2. For cleaning groutlines use the Universal
AGRESSOR Brush.
CLEANING PROCEDURE
1. Remove trash receptacles, etc., from the area to
be cleaned.
2. Sweep or dust mop the floor.
3. Remove gum, labels or other debris from the
surface with a scraper.
4. Apply the pre-mixed solution generously with a
wet mop (or use optional tank) to a section of the
floor. Let solution stand for 5 to 10 minutes. Do
not allow solution to dry on the floor.
5. Plug the power cord of the machine into a
properly grounded outlet.
6. Adjust handle to a comfortable height.
7. Depress the “ON” switch to start machine.
(Depress the “OFF” switch to stop machine.)
The brush-drive motor is
thermally protected and
should an overload condition occur causing the
motor to stop, the machine will not start until the
“ON” switch is depressed.
8. Start cleaning at the farthest corner and work
toward the door. For best results, pull machine
backwards at a steady pace.
9. Keep the machine moving to avoid possible
damage to the grout.
10. Use a bristle hand brush to clean inside corners
and small areas not accessible by machine.
11. After scrubbing, rinse floor with clean water. Use
a wet vacuum to pick up loosened dirt an
solution.
12. Groutlines will appear dark at first, but will lighten
after they dry.