Windsor Saber Blade 12 - Manual (Page 9)

English
9
Î Set main switch for brush/vacuum
operation to “0”.
Î Swivel the appliance handle forward
and arrest in the park position.
Î Disconnect the main plug from the
socket.
Note
If the recovery tank is full the float clos-
es the suction channel. The suction op-
eration is interrupted. Empty the
recovery tank.
ṇ
Warning
Please observe the local provisions re-
garding the wastewater treatment.
Î Turn off the machine.
Î Position the appliance upright and
arrest it in the park position.
Î Remove the solution tank from the
appliance.
Î Swivel support bow downward and
remove the recovery tank.
Î Lift the lock and remove the lid of the
recovery tank.
Î Pour out dirt water.
Î Rinse the recovery tank with clear
water.
Î Replace the lid of the recovery tank
and lock it.
Î Insert the recovery tank into the ap-
pliance.
Î Remove the solution tank from the
appliance.
Î Open the cover of the solution tank.
Î Pour out the cleaning liquid.
Î Close the cover of the solution tank.
Î Insert the solution tank into the appli-
ance.
Î Swivel the appliance handle forward
and arrest in the park position.
Î Swivel the pushing handle back-
wards and push the appliance.
or
Î Lift appliance by the carrying handle
and carry it.
ƽ
Danger
First pull out the plug from the mains be-
fore carrying out any tasks on the ma-
chine.
ṇ
Warning
Risk of damage to the appliance on ac-
count of water leakage. Empty the
waste water reservoir and the fresh wa-
ter reservoir prior to performing mainte-
nance on the appliance.
Emptying the recovery tank
Emptying the solution tank
Transport
Maintenance and care