Warning, Operating the spray gun – Wagner SprayTech 0295001 User Manual

Page 5

English

Purging and Priming for Solvent-Based Paint

Thorough cleaning is not necessary when using solvent-based
paint. All you need to do is purge the test fluid from the
system.

1. Secure the return hose into a waste container.
2. Place a full container of paint under the suction tube.
3. Turn the pressure control knob fully counterclockwise to

reduce the pressure to its lowest setting.

4. Set the PRIME/SPRAY

valve to PRIME.

5. Turn the ON/OFF switch

to ON.

6. Slowly turn the pressure

control knob clockwise to
increase the pressure
until fluid starts to come
out of the return hose.
Use only enough pressure to keep the fluid coming out.

7. Turn the pressure control knob fully counterclockwise to

its lowest setting when the test fluid is purged and paint is
coming out of the return hose.

8. Remove the return hose from the waste container and

place it in its operating position above the container of
solvent-based paint.

9. Keep circulating the paint through the system until the

paint coming out of the return hose is free of air bubbles.

10. Turn the pressure control knob fully counterclockwise to

its lowest setting.

The pump is now purged. Skip to Purging and Priming the
Spray Hose.

Purging and Priming the Spray Hose

After the pump is purged and primed, you must do the same
for the spray hose.

If a metal container is used, ground the
gun by holding it against the edge of
the container while flushing. Failure to
do so may lead to a static electric
discharge which may cause a fire.

1. Turn the pressure control

knob fully counterclockwise
to its lowest setting.

2. Set the PRIME/SPRAY

knob to SPRAY.

3. Unlock the spray gun.
4. Turn the pressure control

knob slowly clockwise to
increase pressure.

5. Trigger the gun into a

waste container until all air, water or solvent is purged
from the spray hose and paint is flowing freely.

6. Turn the pressure control knob fully counterclockwise to

its lowest setting.

7. Set the PRIME/SPRAY knob to PRIME and trigger the gun

into the waste container to be sure that no pressure is left
in the hose.

8. Lock the spray gun off.

Pressure Control Knob

WARNING

NOTE: Make certain that the spray gun has no tip

installed.

PRIME/SPRAY Valve

Operating the Spray Gun

POSSIBLE INJECTION HAZARD. Do not spray without the
tip guard in place. Never trigger the gun unless the tip is
in either the spray or the unclog position. Always engage
the gun trigger lock before removing, replacing or
cleaning tip.

Pressure Relief Procedure

Be sure to follow the pressure relief procedure when
shutting the unit down for any purpose, including
servicing or adjusting any part of the spray system,
changing or cleaning spray tips, or preparing for cleanup.

1. Lock the gun by turning the gun trigger lock to the locked

position.

2. Turn the motor off.
3. Turn the pressure control

knob counterclockwise to
its lowest setting.

4. Turn the PRIME/SPRAY

knob to PRIME.

5. Unlock the gun by turning

the gun trigger lock to the
unlocked position.

6. Hold the metal part of the gun firmly to

the side of a metal container to ground
the gun and avoid a build up of static
electricity.

7. Trigger the gun to remove any

pressure that may still be in the hose.

8. Lock the gun by turning the gun trigger lock to the locked

position.

WARNING

Pressure Control Knob

WARNING