Using the table editor – Worth Data 5000 User Manual
Page 51
50
If you do not have your TriCoder turned on and cabled up correctly, or the USB driver is installed incorrectly, you will see this error
message:
USB TriCoder Not Found
You can turn your TriCoder on with the C22 USB Cable connected to your computer and after a short delay it will show up on the
right panel after it enumerates and registers on your PC.
Using the Table Editor
The Table Editor allows you to:
o Load and edit existing tables that are on your computer and download them into your TriCoder and
o Create new tables and download them to your TriCoder
Once you have the table open in the Table Editor, you can change any of the parameters and fields and then download the table back into
your TriCoder.
For more information on using a Table, see
. One thing to remember when using a table is that your TriCoder
programs must configured before you can access the table data on your TriCoder. For more information on programming for tables,
see
Chapter 10: Creating a Custom Program