Watlow Electric 93 - Manual (Page 20)

4 . 2 ■ S e t u p W a t l o w S e r i e s 9 3
Setup
[`LOC] Lock
[``In] Input
[`dEC] Decimal*
[`C_F] Celsius - Fahrenheit*
[``rL] Range Low
[``rH] Range High
[`Ot1] Output 1
[`HSC] Hysteresis Control
[`Ot2] Output 2
[`HSA] Hysteresis Alarm*
[`LAT] Latching*
[`SIL] Silencing*
[`rtd] RTD*
[`rP`] Ramping
[`rT`] Rate*
[`P`L] Power Limiting*
[`dSP] Display
* Parameter may not always appear.
‰
Setup Menu
Figure 4.2b -
The Setup Menu.
NOTE:
While in the Setup
Menu, all outputs are
off.
The Operation Menu will appear as the default menu of the Series 93. The Setup
Menu displays the parameters that configure the Series 93's features to your
application.
Enter the Setup Menu by pressing the ¿Up-arrow and ¯Down-arrow keys si-
multaneously for 3 seconds. The lower display shows the [`LOC] Lock parame-
ter, and the upper display shows its current level. All keys are inactive until you
release both keys. You can reach the Lock parameter from anywhere.
Use the ‰Advance key to move through the menus and the ¿Up-arrow and
¯Down-arrow keys to select data. You will not see all parameters in this menu,
depending on the controller's configuration and model number. After stepping
through the menu it returns to the set point parameter under the Operation
Menu. If no keys are pressed for approximately 60 seconds, the controller returns
to the default display, Process over Set Point.
Figure 4.2a -
Entering the Setup
Menu.
93 93
Entering the Setup Menu