Weider CORe 600 831.15715.0 - Manual (Page 6)

6
ASSEMBLY
1.
Orient the Front Stabilizer (2) so that the square
holes are toward the floor. Attach the Front
Stabilizer to the Front Leg (4) with two M10 x
90mm Carriage Bolts (43) and two M10 Nylon
Locknuts (42).
Do not tighten the Nylon
Locknuts yet.
2
42
42
4
1
43
Square
Holes
Before beginning assembly, make sure
that you have read and understand the
information in the box above. See the
PART IDENTIFICATION CHART on page 5
for help identifying small parts.
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two persons.
• Because of its size, the weight bench should be
assembled in the location where it will be used.
Make sure that there is enough clearance to walk
around the weight bench as you assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
• Assembly requires the included hex key(s)
and the following tools (not included):
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver
Assembly may be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Assembly Easier
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by almost anyone. By setting aside
plenty of time, assembly will go smoothly.
2. Orient the Rear Stabilizer (3) so that the square
holes are on the side shown. Attach the Rear
Stabilizer to the Frame (1) with two M10 x
90mm Carriage Bolts (43) and two M10 Nylon
Locknuts (42).
Do not tighten the Nylon
Locknuts yet.
2
1
42
3
43
42
Square
Holes