Wybron pmn - Manual (Page 16)

16
3. Connect the Power Supply to AC power
Plug the AC cord into a non-dimmed power circuit. The power supply
automatically accommodates 100 - 132 VAC (50/60 Hz) or 170 - 240
VAC (50/60 Hz).
Power at the Coloram II Power Supply is indicated by the red display
which can be viewed from the stage. Power is also indicated on the
bottom of each Color Changer by a red or yellow LED.
The connected Color Changers will automatically "check in" with the
power supply and "initialize" the gelstring installed by doing the
following actions:
1. Moving the gelstring toward the last frame, in search of the
long foil tag.
2. Turning around at the long foil tag and then searching for the
short foil tag at the beginning of the gelstring.
3. Stopping at the short foil tag and staying there if no DMX
signal is present or going to it’s commanded position if DMX
signal is present.
Note: It may take up to 30 seconds before all Color Changers start to
initialize. Upon power up, the Power Supply will scroll a short message
which includes the software version installed in it. The Power Supply
will then initiate a "roll call" which tells the Color Changers to "check in"
and initialize the gel string.
Caution: Do not power the Power Supply from a dimmer. Severe
damage will result and is not covered by product warranty.
4. Set the Power Supply/Color Changer channels
Each color changer is assigned a DMX address to which it will
respond. Valid DMX addresses are 001 - 512.
First, set the first channel for the block of DMX channels selected for
the power supply. Then, set the color changer for the first, second, etc
channel of that block of channels.
For example, if you want a color changer to respond to DMX channel
105, first set the power supply channel block to start on channel 105
and then set the color changer to 1 which is the first channel in the
block of power supply channels - channel 105.