Wolf Appliance Company L342212 - Manual (Page 10)

Pro Hood Liner Installation 10
Before making electrical connections, make sure the
electrical power is turned off at the service panel.
Hood Wiring Connections
BLOWER WIRING
IMPORTANT NOTE: Refer to specific installation instruc-
tions provided with each blower assembly for additional
mounting and wiring instructions.
1) Remove the hood electrical box cover from the back of
the hood liner. Run Romex ® wire from the service panel
to the hood installation location. Insert the Romex ®
wire through the holes in the back of the hood liner to
the electrical box. Refer to the illustration below for the
location of wiring.
2) Using the wire connectors provided, connect black
wire to power supply black wire, white wire to power
supply white wire and green wire to green wire or bare
wire.
3) Place all wiring connections inside the electrical box
and reinstall the cover. Make sure all wires are secure
and that no wires are pinched between the cover and
electrical box.
Hood Liner Installation
The filters must be removed from the hood liner prior to
installation. Refer to hood liner preparation on the previous
page.
Position the hood liner in the desired location on the wall.
Install #10 x 2" (59) screws through the mounting holes on
the back plate. Verify that the screws engage the wall
studs or blocking.
If additional support is required for the hood liner, drill
supplementary mounting holes in the back plate and use
these holes to attach the hood liner to wall framing.
Due to the weight of the hood, be sure to have
adequate assistance for installation.
1 7 / 8 " (48)
3 1 / 2 " (89)
12 1 / 2 "
(318)
Location of hood wiring.