Philips SCD469 - Manual (Page 8)

Mains operation
1 Put the small plug in the socket on the baby unit and insert the adapter in a wall socket.
(Fig. )
Battery operation
The baby unit runs on four 1.5-volt R6 AA batteries (not included). We strongly advise you to use
Philips LR6 PowerLife batteries.
Make sure your hands and the unit are dry when you insert the batteries.
1 Undo the screw of the battery compartment lid with a screwdriver and remove the lid.
(Fig. )
Insert four 1.5V AA batteries.
Make sure the + and - poles of the batteries point in the right direction.
Put the battery compartment lid back on the appliance and fasten the screw with a
screwdriver. (Fig. 5)
Note:Do not mix old and new batteries.
Note:Remove the batteries if you do not intend to use the baby unit for a month or more.
Note:If the batteries are in the unit when you operate it on mains power, check them for leakage every
six months.
Note:When the batteries are low, the battery symbol à on the display and the power light blink. When
the batteries are empty, the power light and the display do not go on at all.
Parent unit
The parent unit has a rechargeable battery pack and can be recharged in the charger. When the
battery pack is fully charged, you can use the parent unit cordlessly for up to 12 hours.
1 Put the small plug into the socket of the charger and put the adapter in a wall socket. (Fig. 6)
Place the parent unit in the charger. (Fig. 7)
The charging light starts to burn red.
Leave the parent unit in the charging base until the battery pack is fully charged.
It takes at least 14 hours to charge the battery pack fully.
The charging light burns red as long as the parent unit is in the charger, even when the battery
pack is fully charged.
Note:When the battery pack is low, the power light and SYSTEM CHECK light blink. When the power
light and SYSTEM CHECK light do not go on at all, the battery pack is empty.
Note:You can also leave the parent unit in the charger to run it from the mains.
Preparing for dial-up mode
Baby unit
1 Follow the instructions above to prepare the baby unit for mains operation.
Insert one connector of the telephone cable supplied in the appropriate plug. Insert the plug
in the wall telephone socket.
Insert the other connector of the telephone cable into the phoneline-in socket of the baby
unit. (Fig. 8)
If you want your telephone to work while the baby unit is in dial-up mode, insert the cable of
the telephone in the phoneline-out socket of the baby unit.
,
,
-
-
-
EngliSh 8