Using the appliance, Regular baby monitor mode, Operating range – Philips SCD469 User Manual

Page 10

When you phone the baby unit to listen to your baby, the baby unit asks you to enter the PIN code

in the language you have selected.

Press the PIN button on the keypad.

PIN and ---- start to blink on the display.

Use the numeric keypad to enter a 4-digit PIN code.

Press the OK button on the keypad to confirm the setting.

Press the Öbutton to set the sensitivity time.

and 10 start to blink on the display.

Sensitivity time is the time after which the baby unit calls the selected telephone number when

it detects a sound.

Use the numeric keypad to enter a time between 10 and 360 seconds. The default setting is 10

seconds.

Press the OK button to confirm the setting.

The baby unit is now ready for dial-up use.

using the appliance

Regular baby monitor mode

Place the parent unit and the baby unit in the same room to test the connection. (Fig. 1)

Make sure the baby unit is at least 1 metre/3 feet away from the parent unit.

Press the POWER button to switch on the baby unit. (Fig. 1)

The display lights up and the power light starts to burn green

After a few seconds, M1 starts to blink on the display. The baby unit is now in Quick Install

mode.

If you want to set up the baby unit for dial-up mode without programming, follow steps 1 to 4

in ‘Programming for dial-up mode with Quick Install’.

If you want to set up the baby unit for use as a regular baby monitor, skip the Quick Install mode

(see step 3 below).

Wait 5 seconds or press the OK button a few times to skip the Quick Install mode. (Fig. 10)

Use the MODE button to select regular baby monitor mode Ä. (Fig. 15)

Pull out the antenna and turn it upwards for proper reception.

Turn the VOLUME control of the parent to a volume position to switch on the parent unit.

(Fig. 16)

The SYSTEM CHECK light starts to burn green when connection has been established

between the units.

Note:It takes about 30 seconds before a connection is established.

Place the baby unit at least 1 metre/ feet away from your baby. (Fig. 17)

Position the parent unit within the operating range of the baby unit. Make sure it is at least 1

metre/ feet away from the baby unit. (Fig. 18)

For more information on the operating range, see section ‘Operating range’ below.

Operating range

The operating range of the baby monitor is 200 metres/600 feet in open air. Depending on the

surroundings and other disturbing factors, this range may be smaller. Indoors the operating range is

up to 50 metres/150 feet.

EngliSh