WhisperKool 17-1103 - Manual (Page 14)

-12-
Placement of Unit
Slide the unit from the outside wall into
your wine cellar with the outer flange
flush to the outside wall. Secure the
flange to the wall through the predrilled
holes. The screws should penetrate the
studs as well as the upper and lower
supports to provide adequate support
for the WhisperKOOL System (see
illustration). Seal all cracks and gaps
around the WhisperKOOL unit with
caulking to prevent air leakage. (If you
use molding, it should be attached to
the walls, never to the WhisperKOOL
unit itself.)
Slide unit into your cellar, and secure all
screws firmly to the studs and supports.
Attach the PDT mounting bracket.
Attach the PDT to the mounting bracket.
Wall Stud
Two-by-Four Upper Support
Wall Stud
2” x 4”
Lower Support
Electrical Outlets
Drain line
Installing Thermostat
Attach the thermostat to the front of the
unit using the mounting bracket. Make
sure the black male plastic plug from the
unit is securely fitted into the female plug
located on the circuit board of the
thermostat. To complete the installation,
insert the small black screws into each
side of the thermostat PDT/PDT Jr.
securing it to the mounting bracket.
Insert the probe into a wine bottle 3/4 full
of water.
Electrical Outlet
The unit is equipped with two electrical
outlets, one for installation inside the
cellar and the other for installation
outside the cellar. Both outlets are
initially covered and secured with screws.
Select the outlet to be used and remove
that cover; the unused outlet must remain
covered to avoid live electrical charge.
Remove side electrical outlet cover for
easy through the wall installation.
Immediately replace cover when install is
completed and prior to powering up unit
if electrical cord is not attached to outlet.