Weslo MOMENTUM 730 ELLIPTICAL EXERCISER 831.28540.0 User Manual

Page 7

9. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be

left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the ellip-

tical exerciser.

8. Apply a small amount of grease to the axle on the left

Disc Crossbar (16). Slide the Left Pedal Arm (11) onto

the axle, and place a Wave Washer (64) on the end of

the axle. Next, slide an M10 Washer (35) onto an M10 x

25mm Patch Screw (22), and tighten the Patch Screw

into the axle.

Hold the lower end of the left Handlebar Arm (5) inside

of the bracket on the Left Pedal Arm (11). Next, apply

grease to a Pedal Arm Bolt Set (40). Attach the Left

Pedal Arm to the left Handlebar Arm with the Bolt Set.

Do not overtighten the Bolt Set; the Handlebar Arm

must pivot freely.

Attach the Right Pedal Arm (not shown) to the right

side of the elliptical exerciser in the same way.

See step 5. Tighten the M10 x 66mm Button Bolts (48).

See step 6. Tighten the M6 x 38mm Button Bolts (50)

in the Handlebar Arms (5).

Grease

22 35