beautypg.com

Weslo MOMENTUM 730 ELLIPTICAL EXERCISER 831.28540.0 User Manual

Page 5

background image

5

2. While another person lifts the back of the Frame (1),

attach the Rear Stabilizer (28) to the Frame with two

M10 x 72mm Carriage Bolts (34) and two M10 Nylon

Locknuts (33).

34

28

1

2

33

33

3. The Console (23) requires three “AA” batteries (not

included); alkaline batteries are recommended. Insert

three batteries into the battery compartment. Make

sure that the batteries are oriented as shown by

the diagram inside the battery compartment.

23

Batteries

3

4. While another person holds the Console (23) near the

Upright (2), connect the console wire to the Upper

Wire (44). Next, attach the ground wire to the Upright

with an M4 x 16mm Screw (42). Insert the console

wire and the Upper Wire into the Upright, and insert

the ground wire into the Console.

Next, attach the Console (23) to the Upright (2) with

four M4 x 16mm Screws (42). Be careful to avoid

pinching the console wire, the ground wire, or the

Upper Wire (44).

Turn the Resistance Knob (63) counterclockwise to

the lowest setting before going to the next step.

4

23

2

44

63

Console Wire

Ground Wire

42

42

5

1

2

33

Make sure that

the wires and

cables do not

get pinched

and damaged

during this

step.

44

53

48

55

63

59

5. While another person holds the Upright (2) near the

Frame (1), connect the Upper Wire (44) to the Reed

Switch Wire (53). Next, connect the Resistance Cable

(63) to the Lower Cable (55) in the following way:

• See drawing A. Pull up on the metal bracket on the

Lower Cable (55), and insert the tip of the

Resistance Cable (63) into the wire clip inside of the

metal bracket.

• See drawing B. Firmly pull the Resistance Cable

(63) and slide it into the metal bracket on the Lower

Cable (55) as shown.

• See drawing C. Using pliers, squeeze together the

prongs on the upper end of the metal bracket.

Push the excess cable and wire down into the Frame

(1). Next, slide the Upright (2) onto the Frame. Be

careful not to pinch the wires or cables. Attach the

Upright with two M10 x 66mm Button Bolts (48), two

M10 Split Washers (59), and two M10 Nylon Locknuts

(33). Do not tighten the Button Bolts yet.

55

55

Metal

Bracket

B

A

C

55

63

63

63