Maintenance and troubleshooting – Weslo MOMENTUM 730 ELLIPTICAL EXERCISER 831.28540.0 User Manual

Page 11

Inspect and tighten all parts of the elliptical exerciser

regularly. Replace any worn parts immediately.

To clean the elliptical exerciser, use a damp cloth and

a small amount of mild soap. Important: Keep liq-

uids away from the console, place only a sealed

water bottle in the water bottle holder, and keep

the console out of direct sunlight. During storage,

remove the batteries from the console.

BATTERY REPLACEMENT

If the console display becomes dim, the batteries

should be replaced; most console problems are the

result of low batteries. To replace the batteries, see

step 4 on page 5 and remove the console from the

upright. Next, see step 3 on page 5 and insert three

batteries into the console. Reattach the console to the

upright, being careful not to pinch the wires.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted. To adjust the reed

switch, you must remove the Left Pedal Arm (11) and

the Left Side Shield (3).

Remove the Pedal Arm Bolt Set (40), the M10 x

25mm Patch Screw (22), the M10 Washer (35), and

the Wave Washer (64) from the Left Pedal Arm (11).

Remove the Left Pedal Arm. Next, remove the two M4

x 25mm Screws (56) and the four M4 x 16mm Screws

(42) from the Left Side Shield (3).

See the drawing below and locate the Reed Switch

(53). Loosen, but do not remove, the indicated M4 x

16mm Screw (42). Slide the Reed Switch slightly

toward or away from the Magnet (58) on the flywheel.

Then, retighten the Screw. Turn the left Pedal Disc (15)

for a moment. Repeat until the console displays correct

feedback. When the Reed Switch is correctly adjusted,

reattach the Left Side Shield (3) and the Left Pedal

Arm (11).

HOW TO ADJUST THE DRIVE BELT

If the pedals slip while you are pedaling, even when

the resistance is adjusted to the highest setting, the

Drive Belt (19) may need to be adjusted. To adjust the

Drive Belt, you must first remove the left side shield.

See HOW TO ADJUST THE REED SWITCH at the

left and remove the left side shield.

Next, loosen the

M8 x 22mm Flat

Head Screw

(41) and turn

the Idler

Adjustment Bolt

(62) until the

Drive Belt (19)

is tight. When

the Drive Belt is

tight, tighten the

Flat Head

Screw. Reattach

the left side shield.

MAINTENANCE AND TROUBLESHOOTING