Weslo MOMENTUM 730 ELLIPTICAL EXERCISER 831.28540.0 - Manual (Page 4)

4
ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included allen wrenches, assembly requires a Phillips screwdriver , an adjustable
wrench , and a rubber mallet .
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST on page 14. The second number is the
quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part is not in the
parts bag, check to see if it has been pre-assembled. If a part is missing, call toll-free 1-866-699-3756.
M4 x 16mm
Screw (42)–5
M10
Washer (35)–2
M10 Split
Washer (59)–2
M10 Nylon
Locknut (33)–6
Pedal Arm Bolt Set (40)–2
M6 Nylon
Locknut (27)–4
M10 x 25mm
Patch Screw (22)–2
M10 x 72mm Carriage Bolt (34)–4 M10 x 66mm Button Bolt (48)–2
M6 x 38mm Button Bolt (50)–4
M6 x 48mm Flat Head
Screw (36)–4
Wave Washer
(64)–2
1. Identify the Front Stabilizer (10), which is narrower than
the Rear Stabilizer (not shown). While another person
lifts the front of the Frame (1), attach the Front
Stabilizer to the Frame with two M10 x 72mm Carriage
Bolts (34) and two M10 Nylon Locknuts (33).
10
33
34
1
1