beautypg.com

Installation instructions, Warning, Tools and parts – Whirlpool Conservator CEDC392JQ0 User Manual

Page 4: Location requirements

background image

4

INSTALLATION INSTRUCTIONS

Tools and Parts

Tools needed

Gather the required tools and parts before starting installation.
Read and follow the safety instructions provided with any tools
listed here.

Parts supplied

Remove parts package from the dryer drum. Check that all parts
listed are included.

Parts needed

Check local codes, existing electrical supply and venting, and
see “Venting Requirements” and “Electrical Requirements”
before purchasing parts.

Mobile home installations require metal exhaust system
hardware

Permanent installations require 4 dryer feet

For ordering information, please reference the “Assistance or
Service” section of this manual. You can also contact the dealer
from whom you purchased your dryer.

Location Requirements

You will need

A location that allows for proper exhaust installation. See
“Venting Requirements.”

A 120-volt, 60-Hz., AC-only, 15- or 20-amp circuit.

A grounded electrical outlet located within 2 ft (61 cm) of
either side of the dryer. See “Electrical Requirements.”

A sturdy floor to support the dryer weight (dryer and load) of
115 lbs (52 kg). The combined weight of a companion
appliance should also be considered.

A level floor with a maximum slope of 1" (2.5 cm) under entire
dryer.

Do not operate your dryer at temperatures below 45ºF (7ºC). At
lower temperatures, the dryer might not shut off at the end of an
automatic cycle. Drying times can be extended.

The dryer must not be installed or stored in an area where it will
be exposed to water and/or weather.

Check code requirements. Some codes limit, or do not permit,
installation of the dryer in garages, closets, mobile homes, or
sleeping quarters. Contact your local building inspector.

Installation Clearances

The location must be large enough to allow the dryer door to
open fully.

Flat-blade screwdriver

Level

Adjustable wrench

Vent clamps

Caulking gun and
compound (for installing
new exhaust vent)

Tin snips (new vent
installations)

1 - Cycle Control (timer)
knob

1 - Push to Start button

4 - Casters

2 - Cord brackets

2 - Screws

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as
gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.

Failure to do so can result in death, explosion, or fire.