Wayne-Dalton DS-75 - Manual (Page 3)

INTRODUCTION
This manual's main function is to assist the installer in correctly installing the doors to ensure safe operation.
Compliance with building codes, enforced in the area, is required.
All Wayne-Dalton DS-75 and DS-100 Windload Rated Mini Roll-Up Doors follow these general instructions.
Additional installation information for the specific door shipped is found with the packing slip. There may also be
bolt and small sealed parts bags with accessory lists, describing proper application.
PREPARATION
Read the installation instructions thoroughly to become familiar
with the names of the various components and their relation to each
other. It is necessary for the installer to determine the following:
ƒ Type of jamb material (masonry or steel) on which the door
mounting angles will be mounted and the type of fasteners
required.
ƒ The dimensions for the opening width, opening height,
headroom, and side room.
ƒ Type of support brackets provided (bearing bracket or
Tension-Pro™ bracket).
MATERIAL
Inspect your door for possible damage or shortage of parts. Immediately report any shortages to your door supplier,
or transit related damage claims to your freight carrier.
CLEARANCES
Compare the door opening dimensions and available clearances against the dimensions listed on the packing slip,
taking special note of the opening width and height.
TOOLS
Commonly used tools for proper installation are:
ƒ Electric drill with 3/8" or 1/2" chuck with nut driver bits.
ƒ Masonry drill or impact hammer and bits.
ƒ Ladders and/or scaffolding.
ƒ Hammer and pliers.
ƒ Large Pipe Wrench (if Tension-Pro bracket).
ƒ Center punch.
ƒ Screwdrivers.
ƒ Drill bits.
ƒ Wrenches, vise grips, and C-clamps.
ƒ Tape measure and a water level.
3