Westinghouse Teco MA7200 Plus - Manual (Page 7)

MA7200 PLUS Inverter 1 to 2 HP PID Fan and Pump Quick Start Manual
__________________________________________________________________
________________________________________________________________
TECO – Westinghouse Motor Company
7
Step 6
– Select Start / Stop Method of Control (Sn-04)
• Before selecting this parameter, ensure the inverter is in the STOP mode.
• The set-point is selected by the keypad (Sn-05=0), and the start / stop method can be from the
keypad or external contact (see Fig. 2a). NOTE: The set-point can also be set from an external
source but commonly it is set from the keypad.
• The parameter (Sn – 04) is set to = 0 (keypad), as factory default. If external contact is desired,
follow the navigation procedure below to set (Sn-04 = 1).