Wagner SprayTech 3000 - Manual (Page 15)

Striping Tip Guide
STRIPING TIP REGULAR PAINTING SPRAY TIP
UNIFORM PATTERN
LIGHT HEAVY
Striping Tips should not be used for regular spraying. Striping tips are designed for a single pass
application, while spray tips are designed for the 1/3 overlap technique used for spray painting.
Spray Tip Replacement: During use high pressure will cause the orifice to grow larger. This destroys the flat
spray pattern or will leave tailing or two heavy lines on the outside of the pattern. When this ocurs replace the
spray tip or excessive paint will be wasted.
STRIPING TIP - ORIFICE SIZE
(Inches)
in (mm) .009 .011 .013 .015 .017 .019 .021 .023 .025 .027 .031 .035
1-2 25-51 113ST 115ST 117ST 119ST
2-4 51-102 215ST 217ST 219ST 221ST
4-6 102-152 315ST 317ST 319ST 321ST
6-8 152-203
Striping Paint
Oil Base Oil Base Latex Latex Latex Latex Latex Latex
Rev-Tip
TM
for Striping
Fan Width (6” from surface)
REV-GUARD
TM
Super Compact
P.N. 561-001
11/16-16 “F” Thread. Fits:
Airlessco, and some ASM,
Wagner, and Campbell Hausfeld.
P.N. 561-002
7/8-14 “G” Thread.
Fits some: Graco, Wagner,
Titan, Airlessco.
560-215
REV-TIP TM Orifice Size
1/2 Fan Width
Sample:
REV-TIP
T M for Striping
P.N. 562-xxxST
Includes Rev-Tip TM , Metal Seal
& O-Ring Seal .
(water @ 2000psi, 138 bar)
(latex paint @ 2000psi,
138 bar/1.36 spec. gr.)
*Pump will support tip worn to next larger size.
Water Flow Rate (gpm) .12 .18 .24 .31 .38 .47 .57 .67 .77 1.03 1.31 1.63 1.80
(lpm) .49 .69 .91 1.17 1.47 1.79 2.15 2.54 2.96 3.90 4.98 6.17 6.81
Paint Flow Rate (gpm) .10 .15 .21 .27 .33 .40 .49 .58 .66 .88 1.12 1.39 1.54
(lpm) .38 .57 .79 1.02 1.25 1.51 1.85 2.20 2.50 3.33 4.24 5.26 5.83
Pump Minimum (gpm) .25 .25 .33 .40 .50 .60 .75 .88 1.0 1.25 1.5 2.0 2.2
Output* (lpm) 1.0 1.0 1.25 1.5 1.9 2.3 2.8 3.3 3.8 4.7 5.7 7.5 8.2
LIGHT
13