Arm assembly – Weider 740 User Manual
Page 8
8
6
6.
Attach the two tubes on the Weight Guide (62) to the
Top Frame (55) in the following manner:
Slide a 5/16” x 6” Bolt (7) through one of the tubes on
the Weight Guide (62) until the tip is barely visible on
the other side. Position a 1/2” x 1” Spacer (51) and
slide the Bolt through it. Then slide the Bolt through
one sidewall of the Top Frame (55).
Position a 1/2” x 1 3/8” Spacer (61) inside the Top
Frame (55) and slide the 5/16” x 6” Bolt (7) through it.
Then slide the Bolt through the other sidewall of the
Top Frame.
Position a 1/2” x 1” Spacer (51) and slide the 5/16” x
6” Bolt (7) through it. Then slide the Bolt through the
other tube on the Weight Guide.
Secure the 5/16” x 6” Bolt (7) with a 5/16” Nylon
Locknut (3) do not tighten at this time.
Tighten all Nylon Locknuts (3) used in steps 1-6.
51
7
Top Frame
(55)
Schematic view from the back
3
61
Weight Guide Tube
51
Weight Guide Tube
7.
Locate and open the parts bag labeled “ARM
ASSEMBLY.”
Press a 1 1/2” Square Inner Cap (32) into the open
tubes on the Press Frame (17).
Align the welded spacers on the Press Frame (17)
with the indicated holes in the Top Frame (55).
Lubricate the 3/8” x 6” Bolt (16). Attach the Press
Frame to the Top Frame with the Bolt and a 3/8”
Nylon Locknut (21).
Make sure the welded tab on the Press Frame (17)
is oriented as shown.
7
Arm Assembly
16 Lubricate
Welded
Spacers
32
17
21
55
Welded Tab
32
8.
Press a 1 3/4” Square inner Cap (77) into each end
of the Right Arm (48).
Wet the lower end of the Right Arm (48) with soapy
water and slide a Foam Roller (71) onto the Arm.
Press a 1” Round Inner Cap (49) into each end of a
Press Handle (46). Attach the Press Handle to the
Right Arm (48) with a 1/4” x 1 3/4” Screw (52), a 1/4”
Flat Washer (10) and a 1/4” Nylon Locknut (2).
Repeat this procedure for the Left Arm (47).
8
77
48
48
2
10
52
77
49
71
46
3
55
62
51
7
61
51