Cable/seat assembly – Weider 740 User Manual
Page 10
10
12. Locate the parts bag labeled “CABLE ASSEMBLY
AND PULLEYS.” For cable identification and rout-
ing during steps 12 through 27, refer to the Cable
Diagram and Cable ID Chart on pages 15 and 16.
Slide a 3/8” Flat Washer (9) and a 1/2” x 1/4” Spacer
(44) onto a 3/8” x 2” Bolt (12). Next, hold a 3 1/2”
Pulley (15) inside the slot in the Top Frame (55), and
insert the Bolt through the Top Frame and the Pulley.
Slide another 1/2” x 1/4” Spacer (44) and another 3/8”
Flat Washer (9) onto the Bolt and tighten a 3/8” Nylon
Jamnut (22) onto the Bolt.
Locate the Short Cable (58). It is about 130” long
and it has a ball on one end and a loop on the
other end. Wrap the end with the ball around the
3 1/2” Pulley (15) in the direction shown.
Attach a 5/16” x 2” Bolt (78), a 1/2” x 1 3/8” Spacer
(61), and a 5/16” Nylon Locknut (3) to the Top Frame
(55) in the indicated location. Make sure that the
Short Cable (58) is between the Pulley (15) and
the Spacer. Next, press a 1 1/2” Square Inner Cap
(32) into the indicated end of the Top Frame.
12
Cable/Seat Assembly
44
58
44
15
9
78
32
12
61
9
22
55
3
14. Remove the pre-attached Pulleys (15) from the “I”-
Plates (20).
Wrap the Short Cable (58) around a 3 1/2” Pulley (15)
in the direction shown. Attach the Pulley and a Cable
Trap (66) to the top hole in the “I”-Plates with a 3/8” x
2” Bolt (12) and a 3/8” Nylon Locknut (21). Note:
Make sure the “I”-Plates are oriented so the end
with two holes is pointed upward. Make sure the
Cable Trap is oriented as shown.
14
58
15
66
21
12
20
13. Remove the pre-attached Pulley (15) from the Large
Pulley bracket (40).
Route the Short Cable (58) through the Large Pulley
Bracket (40) as shown.
Attach a 3 1/2” Pulley (15) inside the Large Pulley
Bracket (40) with a 3/8” x 1 3/4” Bolt (68) and a 3/8”
Nylon Jamnut (22). Make sure the Cable runs over
the top of the Pulley.
Route the Short Cable (58) down through the hole in
the Top Frame (55).
13
68
Hole
58
40
22
15
55
Two
Holes