Weider 740 - Manual (Page 11)

11
16. Attach the loop at the end of the Short Cable (58) to
the Weight Tube (63) with a 5/16” x 1 1/2” Bolt (11)
and a 5/16” Nylon Locknut (3).
16
3
63
58
11
17. Locate the Butterfly Cable (76). It is approximately
87 1/2“ long and it has a closed loop on both
ends.
Attach one end of the Butterfly Cable (76) to the
welded bracket on the back of the Right Arm (48) with
a 3/8” x 1” Bolt (59), a 3/8” Plain Nut (56) and a 3/8”
Nylon Jamnut (22). Note: Make sure the Plain Nut
and the Jamnut are mounted in the order shown
here. Do not overtighten the Nylon Locknut; it
must be possible to pivot the Cable.
17
Welded Bracket
18. Wrap the Butterfly Cable (76) around a Large Pulley
(39) in the direction shown.
Attach the Large Pulley (39) and a Long Cable Trap
(50) to the welded bracket on the right side of the
Upright (42) with a 3/8” x 2 1/2” Bolt (60) and a 3/8”
Nylon Locknut (21). Note: Make sure the Cable Trap
is oriented as shown.
18
50
39
60
76
22
48
56
59
21
76
42
15. Refer to drawing 15a. Remove the 5/16” x 6” Bolt (7),
the two 1/2” x 1” Spacers (51), the 1/2” x 1 3/8”
Spacer (61), and the 5/16” Nylon Locknut (3) from the
Weight Guides (62) and the Top Frame (55).
Refer to drawing 15b. Route the Short Cable (58) up
through the indicated slot in the Top Frame (55). Wrap
the Short Cable around a 3 1/2” Pulley (15) in the
direction shown and slide the Pulley into the slot in
the Top Frame from the back. Attach the Pulley inside
the slot with a 3/8” x 2” Bolt (12), two 1/2” x 1/4”
Spacers (44), two 3/8” Flat Washers (9), and a 3/8”
Nylon Jamnut (22).
Refer to drawing 15a. Re-attach the 5/16” x 6” Bolt
(7), the two 1/2” x 1” Spacers (51), the 1/2” x 1 3/8”
Spacer (61), and the 5/16” Nylon Locknut (3). Make
sure that the Short Cable is between the Pulley
and the Spacer.
Refer to drawing 15b. Press a 1 1/2” Square Inner
Cap (32) into the indicated end of the Top Frame (55).
15a
15
44
32
7
62
55
3
61
51
12
9
22
9
44
58
55
Welded Bracket
15b