Weider 740 - Manual (Page 12)

12
19. Remove the pre-attached Pulleys (15) from the Pulley
Bracket (57).
Wrap the Butterfly Cable (76) around a 3 1/2” Pulley
(15) in the direction shown. Attach the Pulley to the
upper part of the Pulley Bracket (57) with a 3/8” x
1 3/4” Bolt (68) and a 3/8” Nylon Jamnut (22).
19
22
57
76
15
68
20. Wrap the Butterfly Cable (76) around a Large Pulley
(39) in the direction shown.
Attach the Large Pulley (39) and a Long Cable Trap
(50) to the welded bracket on the left side of the
Upright (42) with a 3/8” x 2 1/2” Bolt (60) and a 3/8”
Nylon Locknut (21), as described in step 18. Note:
Make sure the Cable Trap is oriented as shown.
Make sure the Butterfly Cable (76) is routed as
shown in the drawing.
Attach the free end of the Butterfly Cable (76) to the
welded bracket on the Left Arm (47) in the same way
as described in step 17.
20
39
39
42
50
60
76
47
48
21. Start with the end of the Long Cable (23) that is
already attached to the Upright (42). Wrap the Long
Cable around a 3 1/2” Pulley (15) in the direction
shown.
Attach the 3 1/2” Pulley (15) to the indicated side of
the Pulley Bracket (57) by inserting a 3/8” x 2 1/2”
Bolt (60) through the Pulley and the Pulley Bracket.
Thread a 3/8” Nylon Jamnut (22) a couple of turns
onto the Bolt to prevent the Pulley from falling off dur-
ing the following steps. Note: Make sure the Pulley
Bracket is oriented exactly as shown and that the
Pulley is attached on the indicated side.
21
57
60
23
42
22 15
22. Wrap the Long Cable (23) around a 3 1/2” Pulley (15)
in the direction shown.
Attach the 3 1/2” Pulley (15) and a Cable Trap (66) to
the welded bracket on the Base (4) with a 3/8” x 2”
Bolt (12) and a 3/8” Nylon Locknut (21). Note: Make
sure the Pulley is mounted on the correct side of
the welded bracket, as shown here. Make sure the
Cable Trap is oriented as shown.
22
12
15
66
23
4
21
To Pulley
Bracket
From Pulley
Bracket
View from behind
Welded Bracket