Changing air direction, Normal sounds – Whirlpool ACC082XR0 User Manual

Page 12

To select the fan speed (in Cool, Fan Only or Power Saver
mode only):

Press TURBO, HIGH or LOW.

To raise the temperature:

Press the plus button. Room indicator light on air conditioner will
turn off, and Set indicator light on air conditioner will turn on.
Display on air conditioner shows the Temperature control setting.
Each time you press or hold the plus button, the temperature will
increase 1º until it reaches 86°F (30ºC).

NOTE: After 3 seconds, Set indicator light on air conditioner will
turn off, and Room indicator light on air conditioner will turn on.
Display on air conditioner will show the current room
temperature.

To lower the temperature:

Press the minus button. Room indicator light on air conditioner
will turn off, and Set indicator light on air conditioner will turn on.
Display on air conditioner shows the Temperature control setting.
Each time you press or hold the minus button, the temperature
will decrease 1º until it reaches 64°F (18ºC).

To set the Timer for a 1- to 24-hour delay until the air
conditioner turns off (the air conditioner must be On):

1. Press TIMER. Timer indicator light on air conditioner will

flash. Hour indicator light on air conditioner will turn on, and
display on air conditioner will show remaining hours before air
conditioner will turn off.

2. Press the plus or minus button to change delay time (1 to

24 hours).

3. Press TIMER again or wait 10 seconds. Timer indicator light

on air conditioner will remain on. Hour indicator light on air
conditioner will turn off, and Room indicator light on air
conditioner will turn on. Display on air conditioner will show
the current room temperature.

To set Timer to turn on air conditioner, keeping previous
settings:

1. Turn off air conditioner.

2. Press TIMER. Timer indicator light on air conditioner will

flash. Hour indicator light on air conditioner will turn on, and
display on air conditioner will show remaining hours before air
conditioner will turn off.

3. Press the plus or minus button to change delay time (1 to

24 hours).

4. Press TIMER again or wait 10 seconds. Timer indicator light

To set Timer to turn on air conditioner, changing the
previous settings:

1. Turn on air conditioner.

2. Adjust Mode to Auto Cool, Cool, Fan Only, or Power Saver.

NOTE: For Auto Cool mode, go to Step 4.

3. For Cool, Fan Only or Power Saver mode, adjust Fan Speed

to Turbo, High or Low.

4. Adjust temperature between 64°F (18ºC) and 86°F (30ºC).

5. Wait 3 seconds before turning off air conditioner.

6. Press TIMER. Timer indicator light on air conditioner will

flash. Hour indicator light on air conditioner will turn on, and
display on air conditioner will show remaining hours before air
conditioner will turn on.

7. Press the plus or minus button to change delay time (1 to

24 hours).

8. Press TIMER again or wait 10 seconds. Timer indicator light

Changing Air Direction

Use the tabs to direct the air right or left (on some models).
Rotate the whole cartridge to direct air up, down or straight
ahead.

Normal Sounds

When your air conditioner is operating normally, you may hear
sounds such as:

■

Droplets of water hitting the condenser, causing a pinging or
clicking sound. The water droplets help cool the condenser.

■

Air movement from the fan.

■

Clicks from the thermostat cycle.

■

Vibrations or noise due to poor wall or window construction.

■

A high-pitched hum or pulsating noise caused by the modern
high-efficiency compressor cycling on and off.

A. Tabs