Whirlpool ACC082XR0 User Manual
Page 10
10
NOTES:
■
When the air conditioner is off, the Room indicator light is lit
and the display shows the current room temperature.
■
If the room temperature is below 55ºF (13ºC), the display will
show 55ºF (13ºC). If the room temperature is above 99ºF
(37ºC), the display will show 99ºF (37ºC).
■
When the Set indicator light is lit, the display shows the
temperature control setting. See “Temperature” later in this
section.
■
When the Hour indicator light is lit, the display shows the time
remaining on the Timer setting. See “Timer Delay” later in this
section.
1. Remove clear protective film from control panel and front
panel badge (on some models).
2. Press POWER to turn on air conditioner.
NOTE: When air conditioner is turned on for the first time
after it is plugged in, it will display the default settings: Cool
mode, Turbo fan speed, 72°F (22°C) for 3 seconds. When it is
turned on at all other times, it will display the previous
settings for 3 seconds, and then display the room
temperature.
3. Select mode. See “Mode” later in this section.
4. Select fan speed. See “Fan Speed” later in this section.
5. Set temperature. See “Temperature” later in this section.
Mode
1. Press MODE until you see the indicator light come on for the
setting you desire.
2. Choose Auto, Cool, Fan Only or Power Saver.
■
Auto—Cools room while it automatically controls fan
speed. You cannot change fan speed, but you can adjust
temperature by pressing the plus or minus button.
■
Cool—Cools room. You can adjust temperature by
pressing the plus or minus button. You can select fan
speed by pressing FAN SPEED.
■
Fan Only—Only the fan runs. You can select the fan
speed by pressing FAN SPEED, but you cannot adjust the
Temperature control setting. Display shows the current
room temperature.
■
Power Saver—Fan runs only when cooling is needed. You
can select the fan speed by pressing FAN SPEED.
Because the fan does not circulate the room air
continuously, less energy is used, but the room air is not
circulated as often. Use Power Saver when you are
asleep or away from home.
Fan Speed
NOTE: The Fan Speed button will operate only when Cool, Fan
Only or Power Saver mode has been selected.
1. Press FAN SPEED until you see the indicator light come on
for the setting you desire.
2. Choose Turbo, High or Low.
Filter Monitor
1. When Filter indicator light is lit or flashing, remove, clean and
replace air filter. See “Cleaning the Air Filter.”
2. Press and hold FILTER for 3 seconds after cleaning and
replacing the air filter. This resets the Filter Monitor.
NOTE: After 360 hours of fan operating time, the Filter indicator
light will turn on. It will remain on for 180 hours or until you press
FILTER. After 180 hours, it will flash. It will continue flashing until
you press FILTER.
Temperature
■
Press the plus button to raise the temperature. Room
indicator light will turn off, and Set indicator light will turn on.
Display shows the Temperature control setting. Each time you
press or hold the plus button, the temperature will increase
1º until it reaches 86°F (30°C).
NOTE: After 3 seconds, Set indicator light will turn off, and
Room indicator light will turn on. Display will show the current
room temperature.
■
Press the minus button to lower the temperature. Room
indicator light will turn off, and Set indicator light will turn on.
Display shows the Temperature control setting. Each time you
press or hold the minus button, the temperature will decrease
1º until it reaches 64°F (18°C).
NOTE: After 3 seconds, Set indicator light will turn off, and
Room indicator light will turn on. Display will show the current
room temperature.