Wachsmuth & Krogmann MIQ-FE-65 - Manual (Page 9)

OPERATION
How to Start Jigsaw
1. Before you start make sure your saw blade and guard is secure.
2. Plug cord into power outlet.
3. Place saw near cutting surface. Make sure saw blade is down.
4. Position Speed Adjust Dial to desired stroke rate.
5. To start saw, press and hold the On/Off trigger switch.
6. To stop saw, release the On/Off trigger switch than remove saw from cutting
surface.
General Cutting
Hold your saw firmly in front and clearly away from you. Make sure saw blade is clear of
any foreign material and that power cord and extension cord are out of the blade path.
Be sure material to be cut is held firmly. Small work pieces should be securely clamped
in a vise or clamped to the work bench or table. Mark the line of cut clearly. Squeeze the
Trigger Switch to start the cutting action. Set the Guard on the work surface, then move
the saw blade into the work. DO NOT FORCE. Use only enough pressure to keep the saw
cutting. Allow the saw blade and saw to do the work.
Variable Speed Control
The variable speed control is a 6-position speed dial switch located on the top front of
the blade. By rotating the switch from 1 to 6, the blade speed can be set from 500 to
3000 SPM.
Stroke rate should be set for specific material being cut.
Continuous Rotation
Press and hold the On/Off trigger switch at the same
time press the locking button. Pressing the locking
button locks the tool into operating continuously.
Pressing the On/Off trigger switch again will release
the locking button to allow the tool to operate
normally.
Fig. 4
8