Wachsmuth & Krogmann MIQ-FE-65 User Manual
Page 11
Laser Guide Line
The saw is equipped with a battery powered laser guide which is
designed to aid alignment of the blade with your cutting line. Push
the rocker switch located on the battery compartment cover of the
laser guide to turn it On or Off.
To replace the batteries, pull the upper part of the battery
compartment cover up and then slide the lower part of the battery
compartment cover away from the compartment.
FIG. 7
Warning:
1. Do not try to pull out the lower part of the battery
compartment cover away from the battery
compartment. Instead slide it out.
2. Do not try to loosen or tighten the screw through the
screw hole on the battery compartment cover. This will
cause laser guide line misalignment.
3. Be careful to observe the polarity indicated in the
battery compartment.
Fig. 8
MAINTENANCE
1. Unplug saw. DO NOT ATTEMPT any maintenance on the saw when saw is
plugged into power outlet.
2. Keep the Cooling Vents on the motor housing clean and unobstructed at all times.
Blow out any dust and dirt at regular intervals.
3. Never use any abrasive cleaning agents to clean the plastic parts.
4. This saw has been sufficiently lubricated from the factory therefore the saw does
not need any additional lubrication during the lifetime of the saw.
SERVICE CENTER
If you have any question in regards to the operation of this power tool or are in need of
a spare part please contact our service center at:
Wachsmuth & Krogmann, Inc.
Tel: 1-888-367-7373
(Business hours Mon-Fri 9:00am - 4:00pm CT)
Website: http://www.wk-usa.com
ENVIRONMENTAL PROTECTION
If the tool should no longer work at all, please make sure that it is disposed in an
environmentally friendly way, by handing it into a public collection point. Please do not
put it with your household waste.
10