Wachsmuth & Krogmann MIQ-FE-65 - Manual (Page 10)

Bevel Cutting
Warning: Before adjusting the cutting angles, be sure the saw is unplugged from the
power supply.
The base plate can be tilted to cut any angle between 0 and 45 degrees right and left.
Loosen the base plate adjustment screw and then rotate the base plate left or right to
the desired angle. Tighten the base plate adjustment screw to secure base plate.
Fig. 5
Note: The base plate has a scale for setting 0 to 45 degrees. Use a protractor to set
other angles.
Orbital Cutting
The cutting mode selector can be adjusted to select the
straight cutting mode or orbital cutting mode. This saw
has 4 position settings. The setting marked 0 is for
straight cutting and the settings marked I, II and III are
for orbital cutting.
Use of higher Orbit settings when performing intricate
scroll cuts may cause blade breakage. Use lower orbit
settings for scrolling. Orbit position “0” will produce the
most accurate cuts with less splintering and the longest
blade life.
Fig. 6
9