Warning – Weider 831.15395.1 User Manual

Page 14

ATTACHING THE ACCESSORIES

To attach a Short Handle (49) to a high pulley, first

attach the high pulley to the resistance system (see

ATTACHING THE HIGH PULLEYS AND LEG LEVER

on page 13). Then, attach the Short Handle to the

Short Cable (33) with a Cable Clip (51).

The Long Handles (not shown) and the Ankle Strap

(not shown) can be attached to the Long Cable (80)

with Cable Clips (51). Attach the Leg Press Strap (not

shown) to both ends of the Long Cable, or the optional

lat bar to the Short Cables (33), with two Cable Clips.

Note: A lat bar is an optional accessory for the

resistance system. To purchase a lat bar, please call

1-877-992-5999 and ask for model number

WEMC0442.

“U”-Channel

Resistance

Bars

ADJUSTING THE RESISTANCE

To add resistance, hold a “U”-channel on the 10-

Pound Center Resistance Bar (44) firmly and push

the end of a resistance bar under it. Repeat with the

other end of the resistance bar. If more resistance is

needed, add one resistance bar at a time.

Note: When adding resistance, always start with the

heaviest resistance bar to be used, and finish with the

lightest resistance bar. When removing resistance

bars from the “U”-channels, start with the lightest

resistance bar and finish with the heaviest.

Note: The resistance system uses progressive resist-

ance. As the resistance bars begin to bend, the

amount of resistance will increase gradually. As the

resistance bars bend further, the resistance will

increase rapidly.

Additional resistance can be added to the resistance

system. To purchase more resistance, please call

1-877-992-5999 and asking for model number

WEMC0642 (100-Pound MAX PACK) or WEMC0942

(200-Pound MAX PACK).

WARNING:

When adding resist-

ance, make sure that both ends of the resist-

ance bar rest under the two “U”-channels. The

rings on the Removable Resistance Bars (36,

67) must be pushed against the Tray (35). Do

not add or remove resistance bars from the

“U”-channels while the end of the Long Cable

(80) is pulled out.